Home
Quickstart Guide
Introduction RIO Academic RIO Application examples Your first RT app Your first FPGA app
Real-Time
Basic procedures System admin File system I/O monitor System controller architecture Timed loops Inter-process communication RT/Host communication RT/FPGA communication FPGA personalities Interrupts Datalogger (file I/O)
FPGA
Design flow Simulation Inter-process communication RT/host communication Derived clock domain IP blocks FPGA personality
Networking
Get connected Email Web services UDP TCP IP addresses
Site Map
Guides Code examples Procedures Tags LabVIEW block diagram elements Targets Communications All pages
Glossary How to use About
RIO Developer Essentials Guide for Academia
RT procedure

Set RT system time and date from a browser

Browse directly to the Academic RIO Device network address to use the Web-Based Monitoring and Configuration tool. Note: The NI ELVIS III does not have the Web Interface for modifying these settings. Use NI Measurement and Automation Explorer (NI MAX) to modify these settings instead.

https://youtu.be/1b5AmovU2TI (1:14)

Procedure

  1. Connect the Academic RIO Device by its USB cable to establish the “USBLAN” network
  2. Select one of these supported browsers: Firefox, Internet Explorer, or Safari
  3. Enter the network address 172.22.11.2
  4. Select the “Time Configuration” page
  5. Select the correct date, time, and time zone
  6. Click Save
  7. Optional, but recommended: Click Restart to cause the current time/date to be stored as the initial time/date each time the Device boots up; a reboot requires several minutes

Tips

For more information

  1. Monitoring and Configuring a Remote Device from a Web Browser (http://zone.ni.com/reference/en-XX/help/371361G-01/lvhowto/ni_webconfig/)
    Use your web browser to monitor and configure your RIO device.

Related content

Tags:

Targets: